Interface Cable - Printronix L5535 Maintenance Manual

Chapter 2
Cable Connections

Interface Cable

Now connect the printer to the computer. To connect the cables, refer to the
following illustration and perform the steps listed below.
NOTE: To avoid possible electrical interference, separate the AC power cord
1. Connect the interface cable to the appropriate printer interface connector
and to the host computer.
2. Leave the free end of the power cord unplugged for now. (It will be
plugged into the AC line receptacle in a later procedure.)
IMPORTANT
After you complete the remaining procedures in this chapter, you must
properly configure the printer for the appropriate interface. For
information on configuring the printer, see "Host I/O Interfaces" in the
User's Manual.
Serial Port
Diagnostic Port
Reserved
I–40
and the interface cable.
Optional
Coax/Twinax
Port
Parallel Port or
optional PrintNet Port
(Parallel Port shown)