Error Code 5C - Stacker Fail; Error Codes 60 Through 62, 6E, And 70 - Cut-Sheet Comm. Fail; Error Code 63 - Cut-Sheet Feeder Fail - Printronix L5535 Maintenance Manual

Chapter 4
Status Messages And Error Messages
Error Code 5C — Stacker Fail
1. Press the AUTO key on the stacker.
If the problem persists, go to step 2.
2. Check the elevator down sensor, EDS. Turn off power to the printer.
Check the continuity of the harness wiring between the stacker controller
board and the EDS.
If the harness continuity is OK, go to step 3.
3. Replace the stacker controller board.
If the problem persists, replace the power paper stacker.
Error Codes 60 through 62, 6E, and 70 — Cut-sheet
Comm. Fail
Error Code 63 — Cut-sheet Feeder Fail
1. Check the cut sheet feeder interface harness connectors.
a. Verify that the harness connector is connected properly to MC board
b. Verify that the harness connector is connected properly to power
c. Verify that the harness connectors are connected properly to
2. Turn off power to the printer and check the continuity of the cut sheet
feeder harness wiring between the feeder and the rest of the printer.
a. Check the continuity of the harness between connector CN3 on the
I–162
CHECKLIST: ELEVATOR DOWN SENSOR (EDS)
EDS HARNESS
STACKER CONTROLLER BOARD
STACKER
CHECKLIST: CUT SHEET FEEDER INTERFACE HARNESS
MC BOARD
FEEDER BOARD
CUT SHEET FEEDER
connector CN3, the cut sheet feeder connector on the MC board.
supply board connector CN10, the cut sheet feeder connector on the
printer DC power supply.
connectors J60101 and J03102 on the feeder board.
If the connectors are OK, go to step 2.
MC board and connector J03102 on the feeder board.