Loading Cut Sheet Paper - Printronix L5535 Maintenance Manual

Loading Cut Sheet Paper

If the printer is equipped with the cut sheet paper feed option, upper and lower
paper input cassettes are provided. When printing on cut sheet paper, the
operator can select the face down tray (default) or the face up tray from the
control panel.
In order to minimize the possibility of a paper jam:
•
•
•
•
•
•
•
The procedure for loading cut sheet paper assumes the following:
•
•
•
•
•
1. Pull out the desired paper cassette and remove its cover.
2. If you need to change the cassette for a different paper size, refer to
Only use xerographic quality paper.
Load paper in a cassette which has been adjusted for the exact paper
size. (To set the cassette for the paper size, see page I–59.)
Do not gather loose paper for use.
Do not use wrinkled, folded, or moist paper. If paper becomes moist or
wavy, remove those sheets from the cassette.
Do not leave paper in the cassettes overnight.
Always store unused paper in a clean, dry area protected from sunlight.
If a paper package is opened but not fully used, rewrap and seal the
package and store it properly for future use.
The power switch is OFF.
The power cord is unplugged.
The printer front cover is closed.
The drum, developing unit, toner cartridge, and waste toner bottle have
been installed.
Fanfold paper has been loaded.
page I–59 and change the cassette, then return to this procedure.
I–57