3Com 4210 PWR Configuration Manual page 487

n
c
Displaying Debugging
Status
Figure 170 The relationship between the protocol and screen debugging switch
Debugging
information
1
Protocol
debugging switch
ON
Screen
output
switch
Displaying debugging information on the terminal is the most commonly used
way to output debugging information. You can also output debugging
information to other directions. For details, refer to "Information Center" on
page 451.
You can use the following commands to enable the two switches.
Table 356 Enable debugging and terminal display for a specific module
Operation
Enable system debugging for
specific module
Enable terminal display for
debugging
CAUTION: The output of debugging information affects the system operation.
Disable all debugging after you finish the system debugging.
Table 357 Display the current debugging status in the system
Operation
Display all enabled debugging
on the switch
2 3
ON
OFF
1
3
OFF
Command
debugging module-name [
debugging-option ]
terminal debugging
Command
display debugging [ unit
unit-id ] [ interface
interface-type
interface-number ] [
module-name ]
Debugging the System
Debugging
information
2
1
Protocol
OFF
debugging
switch
1
Screen
output
ON
switch
1
Description
Required
Disabled for all modules by
default.
Required
Disabled by default.
Description
You can execute the display
command in any view.
485
3
ON
3
3