Managing From An Nms - 3Com 4210 PWR Configuration Manual

Managing from an
NMS
Table 27 Enable/Disable the WEB Server
Operation
Disable the Web server undo ip http
n
To improve security and prevent attack to the unused Sockets, TCP 80 port (which
is for HTTP service) is enabled/disabled after the corresponding configuration.
Enabling the Web server (by using the undo ip http shutdown command)
■
opens TCP 80 port.
Disabling the Web server (by using the ip http shutdown command) closes
■
TCP 80 port.
You can access your switch from a network management station (NMS), and then
configure and manage the switch through the switch's management agent.
Simple network management protocol (SNMP) is applied between the NMS and
the agent. Refer to "SNMP Configuration" on page 351 and "RMON
Configuration" on page 361 for related information.
To manage your switch from an NMS, you need to perform related configuration
on both the NMS and the switch.
Table 28 Requirements for logging into a switch through an NMS
Item
Switch
NMS
Figure 25 Network diagram for logging in through an NMS
Switch
NMS
Command
shutdown
The IP address of the VLAN interface of the switch is configured. The
route between the NMS and the switch is reachable. (Refer to "IP
Addressing Configuration" on page 87.)
The basic SNMP functions are configured. ("SNMP Configuration" on
page 351 and "RMON Configuration" on page 361 for related
information.)
The NMS is properly configured. (Refer to the user manual of your NMS
for related information.)
Network

Managing from an NMS

Description
Required
Requirement
59