3Com 4210 PWR Configuration Manual page 388

386 C 35: NTP C
HAPTER ONFIGURATION
2 To synchronize Device B, you need to perform the following configurations on
Device A.
# Enable the NTP authentication function.
[DeviceA] system-view
[DeviceA] ntp-service authentication enable
# Configure an MD5 authentication key, with the key ID being 42 and the key
being aNiceKey.
[DeviceA] ntp-service authentication-keyid 42 authentication-mode md5 aNiceKey
# Specify the key 42 as a trusted key.
[DeviceA] ntp-service reliable authentication-keyid 42
(After the above configurations, the clock of Device B can be synchronized to that
of Device A.) View the status of Device B after synchronization.
[DeviceB] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 1.0.1.11
Nominal frequency: 100.0000 Hz
Actual frequency: 100.1000 Hz
Clock precision: 2^18
Clock offset: 0.66 ms
Root delay: 27.47 ms
Root dispersion: 208.39 ms
Peer dispersion: 9.63 ms
Reference time: 17:03:32.022 UTC Thu Apr 2 2007 (BF422AE4.05AEA86C)
The output information indicates that the clock of Device B is synchronized to that
of Device A, with a clock stratum level of 3, one stratum level lower than that
Device A.
# View the information about NTP sessions of Device B (You can see that a
connection is established between Device B and Device A).
<DeviceB> display ntp-service sessions
source
************************************************************************* [12345]
1.0.1.11 127.127.1.0
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations :
reference stra reach poll
2 255 64
1
now offset delay disper
8 2.8 17.7 1.2