3Com 4210 PWR Configuration Manual page 509

Table 378 Configure TCP test on Remote-Ping client
Operation
Configure the destination
address
Configure the destination
port
Configure the source IP
address
Configure the source port
Configure the test type
Configure the number of
probes per test
Configure the automatic test
interval
Configure the probe timeout
time
Configure the maximum
number of history records that
can be saved
Configure the type of service
Start the test
Command
destination-ip ip-address
destination-port
port-number
source-ip ip-address
source-port port-number
test-type { tcpprivate |
tcppublic }
count times
frequency interval
timeout time
history-records number
tos value
test-enable
Remote-Ping Configuration
Description
Required
This IP address and the one
configured on the
Remote-Ping server for
listening services must be the
same.
By default, no destination
address is configured.
Required in a Tcpprivate test
A Tcppublic test is a TCP
connection test on port 7. Use
the Remote-Ping-server
tcpconnect ip-address 7
command on the server to
configure the listening service
port; otherwise the test will
fail. No port number needs to
be configured on the client;
any destination port number
configured on the client will
not take effect.
By default, no destination port
number is configured.
Optional
By default, the source IP
address is not specified.
Optional
By default, no source port is
specified.
Required
By default, the test type is
ICMP.
Optional
By default, one probe is made
per time.
Optional
By default, the automatic test
interval is zero seconds,
indicating no automatic test
will be made.
Optional
By default, a probe times out
in three seconds.
Figure 177 Optional
By default, the maximum
number is 50.
Optional
By default, the service type is
zero.
Required
507