3Com 4210 PWR Configuration Manual page 460

458 C 40: I
HAPTER NFORMATION
n
C
ENTER
Table 344 Set to output system information to the console
Operation
Enable system information
output to the console
Configure the output rules of
system information
Set the format of time stamp
in the output information
To view the debugging information of some modules on the switch, you need to
set the type of the output information to debug when configuring the system
information output rules, and use the debugging command to enable debugging
for the corresponding modules.
Table 345 Default output rules for different output directions
Output Modules
direction allowed
Console default (all
modules)
Monitor default (all
terminal modules)
Log host default (all
modules)
Trap buffer default (all
modules)
Log buffer default (all
modules)
SNMP NMS default (all
modules)
Enabling system information display on the console
After setting to output system information to the console, you need to enable the
associated display function to display the output information on the console.
Table 346 Enable the system information display on the console:
Operation
Enable the
debugging/log/trap
information terminal display
function
Command
info-center console channel
{ channel-number |
channel-name }
info-center source {
modu-name | default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
info-center timestamp { log
| trap | debugging } { boot |
date | none }
LOG TRAP
Enable
d/disab Severit Enabled/
led y disabled
Enabled warning Enabled
s
Enabled warning Enabled
s
Enabled informat Enabled
ional
Disabled informat Enabled
ional
Enabled warning Disabled
s
Disabled debuggi Enabled
ng
Command
terminal monitor
Description
Optional
By default, the switch uses
information channel 0 to
output log/debugging/trap
information to the console.
Optional
Refer to Table 345 for the
default output rules of system
information.
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is boot.
DEBUG
Enabled/
Severity disabled Severity
debuggin Enabled debuggin
g g
debuggin Enabled debuggin
g g
debuggin Disabled debuggin
g g
warnings Disabled debuggin
g
debuggin Disabled debuggin
g g
warnings Disabled debuggin
g
Description
Optional
Enabled by default.