3Com 4210 PWR Configuration Manual page 360

358 C 33: SNMP C
HAPTER ONFIGURATION
Thus, the NMS is able to access Switch A and receive the trap messages sent by
Switch A.
Network diagram
Figure 107 Network diagram for SNMP configuration
10.10.10.1
NMS
Ethernet
Network procedure
# Enable SNMP agent, and set the SNMPv1 and SNMPv2c community names.
<4210> system-view
[4210] snmp-agent
[4210] snmp-agent sys-info version all
[4210] snmp-agent community read public
[4210] snmp-agent community write private
# Set the access right of the NMS to the MIB of the SNMP agent.
[4210] snmp-agent mib-view include internet 1.3.6.1
# For SNMPv3, set:
SNMPv3 group and user
■
security to the level of needing authentication and encryption
■
authentication protocol to HMAC-MD5
■
authentication password to passmd5
■
encryption protocol to DES
■
encryption password to cfb128cfb128
■
[4210] snmp-agent group v3 managev3group privacy write-view internet
[4210] snmp-agent usm-user v3 managev3user managev3group authentication
-mode md5 passmd5 privacy-mode des128 cfb128cfb128
# Set the VLAN-interface 2 as the interface used by NMS. Add port Ethernet 1/0/2,
which is to be used for network management, to VLAN 2. Set the IP address of
VLAN-interface 2 as 10.10.10.2.
[4210] vlan 2
[4210-vlan2] port Ethernet 1/0/2
[4210-vlan2] quit
[4210] interface Vlan-interface 2
[4210-Vlan-interface2] ip address 10.10.10.2 255.255.255.0
[4210-Vlan-interface2] quit
# Enable the SNMP agent to send Trap messages to the NMS whose IP address is
10.10.10.1. The SNMP community name to be used is "public".
10 .10 .10 .2
Switch A