3Com 4210 PWR Configuration Manual page 167

Specifying Whether the
Link Connected to a Port
Is Point-to-point Link
n
Configuration example
# Configure Ethernet 1/0/1 as an edge port.
1 Configure Ethernet1/0/1 as an edge port in system view
<4210> system-view
[4210] stp interface Ethernet1/0/1 edged-port enable
2 Configure Ethernet 1/0/1 as an edge port in Ethernet port view
<4210> system-view
[4210] interface Ethernet1/0/1
[4210-Ethernet1/0/1] stp edged-port enable
A point-to-point link directly connects two switches. If the roles of the two ports at
the two ends of a point-to-point link meet certain criteria, the two ports can turn
to the forwarding state rapidly by exchanging synchronization packets, thus
reducing the forward delay.
You can determine whether or not the link connected to a port is a point-to-point
link in one of the following two ways.
Specify whether the link connected to a port is point-to-point link in
system view
Table 117 Specify whether the link connected to a port is point-to-point link in system
view
Operation
Enter system view
Specify whether the link
connected to a port is
point-to-point link
Specify whether the link connected to a port is point-to-point link in
Ethernet port view
Table 118 Specify whether the link connected to a port is point-to-point link in Ethernet
port view
Operation
Enter system view
Enter Ethernet port view
Specify whether the link
connected to a port is a
point-to-point link
If you configure the link connected to a port in an aggregation group as a
■
point-to-point link, the configuration will be synchronized to the rest ports in
the same aggregation group.
If an auto-negotiating port operates in full duplex mode after negotiation, you
■
can configure the link of the port as a point-to-point link.
After you configure the link of a port as a point-to-point link, the configuration
applies to all the spanning tree instances the port belongs to. If the actual physical
Command
system-view
stp interface interface-list
point-to-point { force-true |
force-false | auto }
Command
system-view
interface interface-type
interface-number
stp point-to-point {
force-true | force-false |
auto }
Configuring Root Bridge
Description
-
Required
The auto keyword is adopted
by default.
Description
-
-
Required
The auto keyword is adopted
by default.
165