3Com 4210 PWR Configuration Manual page 260

258 C 21: AAA C
HAPTER
Configuring the
Attributes of Data to be
Sent to RADIUS Servers
n
ONFIGURATION
Table 196 Set the status of RADIUS servers
Operation
Create a RADIUS scheme and
enter its view
Set the status of the primary
RADIUS
authentication/authorization
server
Set the status of the primary
RADIUS accounting server
Set the status of the
secondary RADIUS
authentication/authorization
server
Set the status of the
secondary RADIUS accounting
server
Table 197 Configure the attributes of data to be sent to RADIUS servers
Operation
Enter system view
Create a RADIUS scheme and
enter its view
Set the format of the user
names to be sent to RADIUS
server
Set the units of data flows to
RADIUS servers
Set the MAC address format
of the Calling-Station-Id (Type
31) field in RADIUS packets
Set the source IP address of
outgoing RADIUS messages
Generally, the access users are named in the userid@isp-name format. Here,
■
isp-name after the "@" character represents the ISP domain name, by which
the device determines which ISP domain a user belongs to. However, some old
Command
radius scheme
radius-scheme-name
state primary
authentication { block |
active }
state primary accounting {
block | active }
state secondary
authentication { block |
active }
state secondary accounting
{ block | active }
Command
system-view
radius scheme
radius-scheme-name
user-name-format {
with-domain |
without-domain }
data-flow-format data {
byte | giga-byte | kilo-byte |
mega-byte } packet {
giga-packet | kilo-packet |
mega- packet | one-packet }
calling-station-id mode {
mode1 | mode2 } {
lowercase | uppercase }
RADIUS scheme view
nas-ip ip-address
System view
radius nas-ip ip-address
Remarks
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Optional
By default, the primary
RADIUS servers in the default
RADIUS scheme "system" are
in the active state, the
secondary servers in the
scheme are in the block state,
and all RADIUS servers in all
other RADIUS schemes are in
the block state.
Remarks
-
Required
By default, a RADIUS scheme
named "system" has already
been created in the system.
Optional
By default, the user names
sent from the switch to
RADIUS server carry ISP
domain names.
Optional
By default, in a RADIUS
scheme, the data unit and
packet unit for outgoing
RADIUS flows are byte and
one-packet respectively.
Optional
By default, the MAC address
format is XXXX-XXXX-XXXX,
in lowercase.
Optional
By default, no source IP
address is set; and the IP
address of the corresponding
outbound interface is used as
the source IP address.