3Com 4210 PWR Configuration Manual page 494

492 C 44: D
HAPTER EVICE
n
c
M
ANAGEMENT
Network diagram
Figure 171 Network diagram for FTP configuration
Configuration procedure
1 Configure the following FTP server-related parameters on the PC: an FTP user with
the username as switch and password as hello, who is authorized with the
read-write right on the directory Switch on the PC. The detailed configuration is
omitted here.
2 On the switch, configure a level 3 telnet user with the username as user and
password as hello. Authentication mode is by user name and password.
Refer to "Logging into an Ethernet Switch" on page 21 for configuration
commands and steps about using telnet.
3 Execute the telnet command on the PC to log into the switch. The following
prompt appears:
<4210>
CAUTION: If the Flash memory of the switch is not sufficient, delete the original
applications before downloading the new ones.
4 Initiate an FTP connection with the following command in user view. Enter the
correct user name and password to log into the FTP server.
<4210> ftp 2.2.2.2
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):switch
331 Give me your password, please
Password:*****
230 Logged in successfully
[ftp]
5 Enter the authorized path on the FTP server.
[ftp] cd switch
6 Execute the get command to download the switch.bin and boot.btm files on the
FTP server to the Flash memory of the switch.
[ftp] get switch.bin
[ftp] get boot.btm
7 Execute the quit command to terminate the FTP connection and return to user
view.
[ftp] quit
<4210>
8 Upgrade the Boot ROM.
<4210> boot bootrom boot.btm
This will update BootRom file on unit 1. Continue? [Y/N] y