PoE Profile
Configuration
Example
PoE Profile Application
Example
Network requirements
Switch A is a Switch 4210 that supports PoE.
Ethernet 1/0/1 through Ethernet 1/0/10 of Switch A are used by users of group A,
who have the following requirements:
The PoE function can be enabled on all ports in use.
■
Signal mode is used to supply power.
■
The PoE priority for Ethernet 1/0/1 through Ethernet 1/0/5 is Critical, whereas
■
the PoE priority for Ethernet 1/0/6 through Ethernet 1/0/10 is High.
The maximum power for Ethernet 1/0/1 through Ethernet 1/0/5 ports is 3,000
■
mW, whereas the maximum power for Ethernet 1/0/6 through Ethernet 1/0/10
is 15,400 mW.
Based on the above requirements, two PoE profiles are made for users of group A.
Apply PoE profile 1 for Ethernet 1/0/1 through Ethernet 1/0/5;
■
Apply PoE profile 2 for Ethernet 1/0/6 through Ethernet 1/0/10.
■
Network diagram
Figure 105 PoE profile application
Network
Ethernet1/0/1 ~Ethernet1/0/5
IP Pone
IP Pone
IP Pone
IP Pone
PoE Profile Configuration Example
Switch A
Ethernet 1/0/6~Ethernet1/0/10
AP
AP
AP
AP
349