3Com 4210 PWR Configuration Manual page 503

Table 373 Configure DHCP test on Remote-Ping client
Operation
Enable the Remote-Ping client
function
Create a Remote-Ping test
group and enter its view
Configure the source
interface
Configure the test type
Configure the number of
probes per test
Configure the maximum
number of history records that
can be saved
Configure the probe timeout
time
Start the test
Display test results
3 Configuring FTP test on Remote-Ping client
Table 374 Configure FTP test on Remote-Ping client
Operation
Enter system view
Enable the Remote-Ping client
function
Create a Remote-Ping test
group and enter its view
Configure the destination IP
address
Configure the source IP
address
Command
Remote-Ping-agent enable
Remote-Ping
administrator-name
operation-tag
source-interface
interface-type
interface-number
test-type dhcp
count times
history-records number
timeout time
test-enable
display Remote-Ping
results [ admin-name
operation-tag ]
Command
system-view
Remote-Ping-agent enable
Remote-Ping
administrator-name
operation-tag
destination-ip ip-address
source-ip ip-address
Remote-Ping Configuration
Description
Required
By default, the Remote-Ping
client function is disabled.
Required
By default, no test group is
configured.
Required
You can only configure a
VLAN interface as the source
interface.
By default, no source interface
is configured.
Required
By default, the test type is
ICMP.
Optional
By default, each test makes
one probe.
Figure 173 Optional
By default, the maximum
number is 50.
Optional
By default, a probe times out
in three seconds.
Required
Required
You can execute the
command in any view.
Description
-
Required
By default, the Remote-Ping
client function is disabled.
Required
By default, no test group is
configured.
Required
By default, no destination
address is configured.
Required
By default, no source IP
address is configured.
501