3Com 4210 PWR Configuration Manual page 438

436 C 38: FTP
HAPTER AND
FTP Banner Display
Configuration Example
SFTP C
ONFIGURATION
Network requirements
Configure the Ethernet switch as an FTP server and the remote PC as an FTP client.
After a connection between the FTP client and the FTP server is established and
login succeeds, the banner is displayed on the FTP client.
An FTP user named "switch" and the password "hello" have been configured
■
on the FTP server.
The IP addresses 1.1.1.1 for a VLAN interface on the switch and 2.2.2.2 for the
■
PC have been configured. Ensure that a route exists between the switch and
the PC.
Configure the login banner of the switch as "login banner appears" and the
■
shell banner as "shell banner appears".
Network diagram
Figure 149 Network diagram for FTP banner display configuration
FTP Server
Vlan-Int1
1.1.1.1 /8
Switch
Configuration procedure
1 Configure the switch (FTP server)
# Configure the login banner of the switch as "login banner appears" and the
shell banner as "shell banner appears". For detailed configuration of other
network requirements, see "Configuration Example: A Switch Operating as an FTP
Server".
<4210> system-view
[4210] header login %login banner appears%
[4210] header shell %shell banner appears%
[4210]
2 Configure the PC (FTP client)
# Access the Ethernet switch through FTP. Enter the user name "switch" and the
password "hello" to log in to the switch, and then enter FTP view. Login banner
appears after FTP connection is established. Shell banner appears after the user
passes the authentication.
C:\> ftp 1.1.1.1
Connected to 1.1.1.1.
220-login banner appears
220 FTP service ready.
User (1.1.1.1:(none)): switch
331 Password required for switch.
Password:
230-shell banner appears
230 User logged in.
ftp>
FTP Client
2.2 .2.2/8
Network
PC