Displaying And Debugging Mac Authentication - 3Com 4210 PWR Configuration Manual

274 C 22: MAC A
HAPTER
Configuring the Quiet
MAC Function on a Port
Displaying and
Debugging MAC
Authentication
C
UTHENTICATION ONFIGURATION
Table 207 Configure the maximum number of MAC address authentication users allowed
to access a port
Operation
Configure the maximum
number of MAC address
authentication users allowed
to access a port
c
CAUTION:
If both the limit on the number of MAC address authentication users and the
■
limit on the number of users configured in the port security function are
configured for a port, the smaller value of the two configured limits is adopted
as the maximum number of MAC address authentication users allowed to
access this port. Refer to "Port Security Configuration" on page 121 the Port
Security manual for a description of the port security function.
You cannot configure the maximum number of MAC address authentication
■
users for a port if any user connected to this port is online
You can configure whether to enable the quiet MAC function on a port. When
this function is enabled, the MAC address connected to this port will be set as a
quiet MAC address if its authentication fails. When this function is disabled, the
MAC address will not become quiet no matter whether the authentication is
failed.
Table 208 Configure the quiet MAC function on a port
Operation
Enter system view
Eneter Ethernet port
view
Configure quiet MAC
function on the port
After the above configuration, you can execute the display command in any view
to display system running of MAC Authentication configuration, and to verify the
effect of the configuration. You can execute the reset command in user view to
clear the statistics of MAC Authentication.
Table 209 Display and debug MAC Authentication
Operation
Display global or on-port
information about MAC
authentication
Clear the statistics of global or
on-port MAC authentication
Command
mac-authentication
max-auth-num user-number
Command
system-view
interface interface-type
interface-number
mac-authenticiaon
intrusion-mode block-mac enable
Command
display mac-authentication
[ interface interface-list ]
reset mac-authentication
statistics [ interface
interface-type
interface-number ]
Description
Required
By default, the maximum
number of MAC address
authentication users allowed
to access a port is 256.
Description
-
-
Required
Enabled by default.
Description
Available in any view
Available in user view