112
C
10: L
A
HAPTER
INK
Configuring a Manual
Aggregation Group
Configuring a Static
LACP Aggregation
Group
n
C
GGREGATION
ONFIGURATION
You can create a manual aggregation group, or remove an existing manual
aggregation group (after that, all the member ports will be removed from the
group).
For a manual aggregation group, a port can only be manually added/removed
to/from the manual aggregation group.
Table 70 Configure a manual aggregation group
Operation
Enter system view
Create a manual
aggregation group
Enter Ethernet port view
Add the Ethernet port to
the aggregation group
Note that:
1 When creating an aggregation group:
If the aggregation group you are creating already exists but contains no port,
■
its type will change to the type you set.
If the aggregation group you are creating already exists and contains ports, the
■
possible type changes may be: changing from dynamic or static to manual, and
changing from dynamic to static; and no other kinds of type change can occur.
When you change a dynamic/static group to a manual group, the system will
■
automatically disable LACP on the member ports. When you change a dynamic
group to a static group, the system will remain the member ports
LACP-enabled.
2 When a manual or static aggregation group contains only one port, you cannot
remove the port unless you remove the whole aggregation group.
You can create a static LACP aggregation group, or remove an existing static LACP
aggregation group (after that, the system will re-aggregate the original member
ports in the group to form one or multiple dynamic aggregation groups.).
For a static aggregation group, a port can only be manually added/removed
to/from the static aggregation group.
When you add an LACP-enabled port to a manual aggregation group, the system
will automatically disable LACP on the port. Similarly, when you add an
LACP-disabled port to a static aggregation group, the system will automatically
enable LACP on the port.
Table 71 Configure a static LACP aggregation group
Operation
Enter system view
Create a static aggregation
group
Command
system-view
link-aggregation group
agg-id mode manual
interface interface-type
interface-number
port link-aggregation group
agg-id
Command
system-view
link-aggregation group
agg-id mode static
Remarks
-
Required
-
Required
Remarks
-
Required