3Com 4210 PWR Configuration Manual page 328

326 C 30: C
HAPTER LUSTER
Table 242 Enable NDP globally and on specific ports
Operation
Enable NDP globally
Enable NDP In system view
on specified
Ethernet
ports In Ethernet
port view
Configuring NDP-related parameters
Table 243 Configure NDP-related parameters
Operation
Enter system view
Configure the holdtime of
NDP information
Configure the interval to send
NDP packets
Enabling NTDP globally and on a specific port
Table 244 Enable NTDP globally and on a specific port
Operation
Enter system view
Enable NTDP globally
Enter Ethernet port view
Enable NTDP on the Ethernet
port
Configuring NTDP-related parameters
Table 245 Configure NTDP-related parameters
Operation
Enter system view
Configure the range to collect
topology information
Command
ndp enable
ndp enable interface
port-list
Enter interface interface-type
Ethernet interface-number
port view
Enable NDP ndp enable
on the port
Command
system-view
ndp timer aging
aging-in-seconds
ndp timer hello seconds
Command
system-view
ntdp enable
interface interface-type
interface-number
ntdp enable
Command
system-view
ntdp hop hop-value
Description
Required
By default, NDP is
enabled globally.
Use either approach.
By default, NDP is
enabled on a port.
Description
-
Optional
By default, the holdtime of
NDP information is 180
seconds.
Optional
By default, the interval to
send NDP packets is 60
seconds.
Description
-
Required
Enabled by default
-
Required
Enabled by default
Description
-
Optional
By default, the system collects
topology information from
the devices within three hops.