3Com 4210 PWR Configuration Manual page 409

# Generate RSA and DSA key pairs.
[4210] public-key local create rsa
[4210] public-key local create dsa
# Set the authentication mode for the user interfaces to AAA.
[4210] user-interface vty 0 4
[4210-ui-vty0-4] authentication-mode scheme
# Enable the user interfaces to support SSH.
[4210-ui-vty0-4] protocol inbound ssh
[4210-ui-vty0-4] quit
# Create local client "client001", and set the authentication password to
"abc", protocol type to SSH, and command privilege level to 3 for the client.
[4210] local-user client001
[4210-luser-client001] password simple abc
[4210-luser-client001] service-type ssh level 3
[4210-luser-client001] quit
# Specify the authentication method of user client001 as password.
[4210] ssh user client001 authentication-type password
Configure the SSH client
■
# Configure an IP address (192.168.0.2 in this case) for the SSH client. This IP
address and that of the VLAN interface on the switch must be in the same
network segment.
# Configure the SSH client software to establish a connection to the SSH server.
SSH Configuration Examples 407