3Com 4210 PWR Configuration Manual page 329

Table 245 Configure NTDP-related parameters
Operation
Configure the device forward
delay of topology collection
requests
Configure the port forward
delay of topology collection
requests
Configure the interval to
collect topology information
periodically
Quit system view
Launch topology information
collection manually
Enabling the cluster function
Table 246 Enable the cluster function
Operation
Enter system view
Enable the cluster function
globally
Configuring cluster parameters
The establishment of a cluster and the related configuration can be accomplished
in manual mode or automatic mode, as described below.
1 Establishing a cluster and configuring cluster parameters in manual mode
Table 247 Establish a cluster and configure cluster parameters in manual mode
Operation
Enter system view
Specify the management
VLAN
Enter cluster view
Configure a IP address pool
for the cluster
Build a cluster
Configure a multicast MAC
address for the cluster
Set the interval for the
management device to send
multicast packets
Command
ntdp timer hop-delay time
ntdp timer port-delay time
ntdp timer
interval-in-minutes
quit
ntdp explore
Command
system-view
cluster enable
Command
system-view
management-vlan vlan-id
cluster
ip-pool
administrator-ip-address {
ip-mask | ip-mask-length }
build name
cluster-mac H-H-H
cluster-mac syn-interval
time-interval
Cluster Configuration Tasks
Description
Optional
By default, the device forward
delay is 200 ms.
Optional
By default, the port forward
delay is 20 ms.
Optional
By default, the topology
collection interval is one
minute.
-
Optional
Description
-
Required
By default, the cluster
function is enabled.
Description
-
Required
By default, VLAN 1 is used as
the management VLAN.
-
Required
Required
name: cluster name.
Required
By default, the cluster
multicast MAC address is
0180-C200-000A.
Optional
By default, the interval to
send multicast packets is one
minutes.
327