3Com 4210 PWR Configuration Manual page 501

Remote-Ping Client
Configuration
1 Configuring ICMP test on Remote-Ping client
Remote-Ping server configuration tasks
Table 370 Remote-Ping server configuration tasks
Item
Enable the Remote-Ping
server function
Configure a listening service
on the Remote-Ping server
Remote-Ping server configuration
Table 371 describes the configuration on Remote-Ping server, which is the same
for Remote-Ping test types that need to configure Remote-Ping server.
Table 371 Remote-Ping server configuration
Operation
Enter system view
Enable the Remote-Ping
server function
Configure a UDP listening
service
Configure a TCP listening
service
Remote-Ping client configuration
After Remote-Ping client is enabled, you can create multiple test groups for
different tests, without the need to enable Remote-Ping client repeatedly for each
test group.
Different types of Remote-Ping tests are somewhat different in parameters and
parameter ranges. The following text describes the configuration on Remote-Ping
client for different test types.
Table 372 Configure ICMP test on Remote-Ping client
Operation
Enter system view
Enable the Remote-Ping client
function
Description
The Remote-Ping server
function is needed only for
jitter, TCP, and UDP tests.
You can configure multiple
TCP/UDP listening services on
one Remote-Ping server, with
each listening service
corresponding to a specific
destination IP address and
port number.
Command
system-view
Remote-Ping-server enable Required
Remote-Ping-server
udpecho ip-address
port-num
Remote-Ping-server
tcpconnect ip-address
port-num
Command
system-view
Remote-Ping-agent enable
Remote-Ping Configuration
Related section
"Remote-Ping server
configuration"
"Remote-Ping server
configuration"
Description
-
Disabled by default.
Required for UDP and jitter
tests
By default, no UDP listening
service is configured.
Required for TCP tests
By default, no TCP listening
service is configured.
Description
-
Required
By default, the Remote-Ping
client function is disabled.
499