3Com 4210 PWR Configuration Manual page 475

9/18/26 port and pwr 9/18/26 port 4210 series switch
Table of Contents

Advertisement

Local Boot ROM and Software Loading
473
Step 5: Click the <Disconnect> button to disconnect the HyperTerminal from the
switch and then click the <Connect> button to reconnect the HyperTerminal to
the switch, as shown in Figure 159.
Figure 159 Connect and disconnect buttons
n
The new baudrate takes effect after you disconnect and reconnect the
HyperTerminal program.
Step 6: Press <Enter> to start downloading the program. The system displays the
following information:
Now please start transfer file with XMODEM protocol.
If you want to exit, Press <Ctrl+X>.
Loading ...CCCCCCCCCC
Step 7: Choose [Transfer/Send File] in HyperTerminal, and click <Browse> in
pop-up dialog box, as shown in Figure 160. Select the software file that you need
to load to the switch, and set the protocol to XModem.
Figure 160 Send file dialog box
Step 8: Click <Send>. The system displays the page, as shown in Figure 161.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents