Enabling Logging For Network Management; Displaying Snmp; Snmp Configuration Examples - 3Com 4210 PWR Configuration Manual

Enabling Logging for
Network Management

Displaying SNMP

SNMP Configuration
Examples
SNMP Configuration
Examples
Table 277 Enable logging for network management
Operation
Enter system view
Enable logging for network
management
n
IUse the display logbuffer command to view the log of the get and set
operations requested by the NMS.
After the above configuration, you can execute the display command in any view
to view the running status of SNMP, and to verify the configuration.
Table 278 Display SNMP
Operation
Display the SNMP information
about the current device
Display SNMP packet statistics display snmp-agent
Display the switch fabric ID of
the current device
Display group information
about the device
Display SNMP user
information
Display Trap list information
Display the currently
configured community name
Display the currently
configured MIB view
Network requirements
An NMS and Switch A (SNMP agent) are connected through the Ethernet. The
■
IP address of the NMS is 10.10.10.1 and that of the VLAN interface on Switch
A is 10.10.10.2.
Perform the following configuration on Switch A: setting the community name
■
and access permission, administrator ID, contact and switch location, and
enabling the switch to sent trap messages.

Enabling Logging for Network Management

Command
system-view
snmp-agent log {
set-operation |
get-operation | all }
Command
display snmp-agent
sys-info [ contact | location |
version ]*
statistics
display snmp-agent {
local-switch fabricid |
remote-switch fabricid }
display snmp-agent group [
group-name ]
display snmp-agent
usm-user [ switch fabricid
switch fabricid | username
user-name | group
group-name ]
display snmp-agent
trap-list
display snmp-agent
community [ read | write ]
display snmp-agent
mib-view [ exclude | include
| viewname view-name ]
357
Description
-
Optional
Disabled by default.
Description
Available in any view.