Table of Contents
Advertisement
29
vlan
VLAN C
OMMANDS
The access point can enable the support of VLAN-tagged traffic passing
between wireless clients and the wired network. Up to 64 VLAN IDs can be
mapped to specific wireless clients, allowing users to remain within the
same VLAN as they move around a campus site.
When VLAN is enabled on the access point, a VLAN ID (a number between
1 and 4094) can be assigned to each client after successful authentication
using IEEE 802.1X and a central RADIUS server. The user VLAN IDs must
be configured on the RADIUS server for each user authorized to access the
network. If a user does not have a configured VLAN ID, the access point
assigns the user to its own configured native VLAN ID.
When VLANs are enabled, the access point's Ethernet port drops
C
:
AUTION
all received traffic that does not include a VLAN tag. To maintain network
connectivity to the access point and wireless clients, be sure that the
access point is connected to a device port on a wired network that supports
IEEE 802.1Q VLAN tags.
The VLAN commands supported by the access point are listed below.
Table 27: VLAN Commands
Command
Function
vlan
Enables a single VLAN for all traffic
management-
Configures the management VLAN for the access
vlanid
point
vlan-id
Configures the default VLAN for the VAP
interface
This command enables VLANs for all traffic. Use the no form to disable
VLANs.
S
YNTAX
[no] vlan enable
D
EFAULT
Disabled
C
M
OMMAND
ODE
Global Configuration
– 232 –
Mode
Page
GC
232
GC
233
IC-W-
234
VAP
Advertisement
Table of Contents
