Filtering Commands - SMC Networks 2555W-AG2 User Manual

7
Command Line Interface
Default
0 (disabled)
Command Mode
Global Configuration
Example
Enterprise AP(config)#mac-authentication session-timeout 1
Enterprise AP(config)#

Filtering Commands

The commands described in this section are used to filter communications between
wireless clients, control access to the management interface from wireless clients,
and filter traffic using specific Ethernet protocol types.
Command
filter local-bridge
filter ap-manage
filter uplink enable
filter uplink
filter ethernet-type enable
filter ethernet-type
protocol
show filters
7-72
Table 7-14. Filtering Commands
Function
Disables communication between wireless clients
Prevents wireless clients from accessing the
management interface
Ethernet port MAC address filtering
Adds or deletes a MAC address from the filtering table
Checks the Ethernet type for all incoming and outgoing
Ethernet packets against the protocol filtering table
Sets a filter for a specific Ethernet type
Shows the filter configuration
Mode Page
GC 7-73
GC 7-73
GC 7-74
GC 7-74
GC 7-74
GC 7-75
Exec 7-76