Selecting Partitions - Abus Secvest 2WAY Installation Instructions Manual

KEY SW MOMENT
Train a key switch (pulse) to the wireless alarm centre. Any change to this zone
changes the state of the alarm centre from active to inactive or vice versa (following
the delay time).
KEY SW LATCHED
A key switch (permanent) can be connected to the burglar alarm centre. Any change to
this zone changes the state of the alarm centre from active to inactive or vice versa
(following the delay time). Please note that you can only operate the alarm centre via
the key switch. If the status is unclear (e.g. key switch closed and deactivated on the
control panel), then the alarm centre may return to active state.
KEY BOX
This zone is mainly used in Scandinavia. If this zone is opened, the trigger is stored in
the memory of the burglar alarm centre. The can also be transmitted via the telephone
dialler. No alarm is triggered.
If a zone of this type is necessary, the user connects the alarm wiring of this zone
(usually the auxiliary contact of a door) to an external key box and the tamper wiring to
the housing switch. If the housing is opened, the wireless centre saves the trigger and
notifies the alarm reception.
EXIT NORM ALM
A zone programmed as "Exit Norm Alm" behaves in a similar way to a "Normal" zone.
However, a zone of this type initiates an alarm when the detector is triggered during
the delay time.

13.9 Selecting partitions

The trained detectors are assigned to Partition 01 as standard.
To assign the detector to another partition, proceed as follows:
Select the Partitions menu item.
At least one partition must be marked with Yes.
Select the relevant partition in which this zone is to be monitored. Confirm by pressing
"Done".
Example: Shared office
An overview of partition characteristics can be found in chapter 10.6 of these
instructions.
The following types can be assigned to one or more partitions: Normal Alarm, Final
Exit, Entry Route, Key Sw Moment and Exit Norm Alm.
If you plan to use internal active partitions, you must ensure that the
internally activated options are identical for all zones used by more than
one partition.
The wireless centre does not allow allocation of the following zone types
to more than one partition: 24 Hour, Fire, Panic and Technical.
49