Ip Network - Abus Secvest 2WAY Installation Instructions Manual

18. IP Network

When an ethernet or GPRS module is attached, this menu allows the user to allocate
the wireless centre an individual IP address. This is then used for IP alarms or the IP
download.
Before programming the wireless centre using the IP network, please
ensure the following:
1. You have understood the basic IP terminology.
2. You have received the necessary information from your Internet
service provider.
With an installed ethernet module, the menu contains the following options:
IP Address
Enter the individual IP address of the wireless alarm centre. The IP address consists of
four groups. Each group is three digits long and separated from the next group by a
"dot", e.g. "192.168.000.001". Press " * " to enter the dot.
If you leave this field blank, the wireless alarm centre uses DHCP
(Dynamic Host Control Protocol) to obtain the IP address from the DHCP
server.
IP Port Number
Enter the port number. This is the port that the alarm centre "listens to" if a downloader
application tries to establish a connection to the alarm centre via the Internet. The
format is a number which can be up to 5 digits long. The default port is 55132.
IP Subnet Mask
Enter the subnetwork mask as needed (e.g. 255.255.255.000). This number has the
same format as the IP address.
Gateway IP Address
Should one be required, enter the gateway IP address. This number has the same
format as the IP address.
When the data detailed above has been entered, you can see which IP
address has been given by the wireless alarm centre by accessing
"System Options" -> "About Comms" in the user menu.
With an installed GPRS module, the menu contains the following options:
IP Address
Enter the individual IP address of the wireless alarm centre, or leave blank. The IP
address consists of four groups. Each group is three digits long and separated from
the next group by a "dot", e.g. "192.168.000.001".
Press "* " to enter the dot.
IP Port Number
Enter the port number or leave blank. This is the port that the alarm centre "listens to" if
a downloader application tries to establish a connection to the alarm centre via the
Internet. The format is a number which can be up to 5 digits long. The default port is
55132.
The wireless alarm centre has no IP address on delivery. The data is
transmitted by the service provider following the first successful
connection over GPRS.
GPRS APN
Enter the corresponding address (Access Point Name) for your network here.
GPRS Username
Enter your user name here.
GPRS Password
Enter your password.
Consult your service provider for your GPRS data!
When the data detailed above has been entered and the connection has
been made, you can see which IP address has been given by the
wireless alarm centre by accessing "System Options" -> "About Comms"
in the user menu.
73