Installer Code; Deactivation In The Event Of Delays; Pa Response; Auto Rearm - Abus Secvest 2WAY Installation Instructions Manual

Function Meaning
Country defaults After confirming the "Country defaults", a list of different
countries is displayed. Each country has its own alarm
settings. This option can be used to select the default
settings for a certain country.
Select the country where the alarm centre is installed.
For Austria or Switzerland, select D. The setting does not
relate to the language selected.
Restore Defaults Confirm this function to reset all settings to the factory
defaults for the selected country.

17.5 Installer code

Enter the new four-digit installer code. You are then prompted to repeat the new
installer code. If both inputs are identical, the new code is stored and is active.
The default installer code is 7890. Security Center recommends
changing this code to one of your choice.
The installer code allows access to the installation menu and can be used to carry out
an installer reset. The installer code cannot be used to activate or deactivate the
system.

17.6 Deactivation in the event of delays

Select whether deactivation of the alarm system using the remote control is only
possible when the delay time was previously started (trigger of entry or exit zone). If
this function is deactivated, then the system can also be deactivated when the delay
time is not running.

17.7 PA response

Select whether an external alarm is also made in the case of a panic alarm (Full), or
whether only a telephone message is sent (Silent).

17.8 Auto rearm

Select how often the system should reactivate itself following expiry of the alarm time
(siren duration).
The system activates all closed zones again, but not the detectors that still send alarm
signals.
When the system is reactivated, an acoustic internal alarm is emitted by the wireless
alarm centre instead of the normal entry tone when a user enters the property.

17.9 Siren Delay

70