Static Test Call; Burg Comms Rearm; Send Tamper As Burg - Abus Secvest 2WAY Installation Instructions Manual

If the function is enabled, the call is made every 24 hours following the last
transmission.
The dynamic test call has the advantage that a test transmission is only
made to the command centre when no transmissions have been made in
the previous 24 hours. If the "Enable/Disable" transmission is
programmed, then it can occur that no test transmissions are made for
several days when the system is enabled or disabled once per day.

20.15 Static Test Call

When a static test call is selected, the system makes a test call at a certain time or day
of the month.
To make a test call at a specific time every day, select Reporting -> ALARMS -> Static
Test Call -> Daily.
Enter a number between 01 and 24 on the display to select the call time. For example,
when 20 is entered, the wireless alarm centre makes a static test call at 20:00 every
day.
To make a test call once per month, select
Reporting -> ALARMS -> Static Test Call -> Monthly.
Enter a number between 01 and 31 on the display to select the day of the month
where the test call should be made. The wireless alarm centre makes a test call at
01:00 on the selected day.
Please note that the wireless alarm centre makes the call arbitrarily up to 16 minutes
before or after the defined time. This ensures that the alarm reception is not
overloaded with test calls from systems set at the same time.
Select
Reporting -> ALARMS -> Static Test Call -> Disabled
to deactivate static test calls.

20.16 Burg Comms Rearm

Select whether the alarm centre should reset channel 3 (burglary) of the Fast Format
report following expiration of the delay time and then rearm it in the event of a new
alarm. If this function is enabled, all zones in the alarm state are hidden. If the function
is disabled, then this channel is also disabled until the alarm centre is deactivated and
reset.

20.17 Send Tamper as Burg

Select whether the wireless alarm centre should transmit a tamper alarm as a burglar
alarm. This is important since there are command centres that cannot evaluate the
resetting of a tamper alarm. If this function is enabled, then a burglar alarm is
transmitted in the event of a tamper message (BA (SIA) or 130 (contact ID)).
82