Arming Station; Outputs; Telecommands; Pendants - Abus Secvest 2WAY Installation Instructions Manual

22.8 Arming Station

The test of the arming station signal is used for displaying the signal strength. The
signal strength should be higher than 3.

22.9 Outputs

A list of all outputs installed on the system is shown on the display. Select the output to
be tested. Press Done to end the test. When the test is ended, check whether the
output has the required status.
Ensure that nobody attempts to activate the WAM using a remote
control or social care transmitter during the test.

22.10 Telecommands

Press the buttons of the remote control (telecommand). The alarm centre displays the
identity, the user, which button was pressed and what the button is used for. The test
of the remote control signal is used for displaying the signal strength. The signal
strength should be higher than 3.

22.11 Pendants

Press the button on the pendant. The identity of the user assigned to the pendant is
displayed. The pendant test is used for displaying the signal strength. The signal
strength should be higher than 3.

22.12 PA Detector

Press both buttons on the PA detector transmitter. The identity of the user assigned to
the panic alarm is displayed. The test of the PA detector is used for displaying the
signal strength. The signal strength should be higher than 3.

22.13 Tag

Hold the chip key (tag) at the top-left corner on the front of the alarm centre. If the chip
key is detected, the alarm centre shows the user assigned to the chip key. Only one
chip key can be assigned to each user. Chip keys are assigned to users in the user
mode.

23. Viewing the log

A list of log displays can be found in the user manual.

24. About Panel

Select the About Panel menu item.
An overview of the displayed data is shown in the following table:
Main S/W: Software status of the firmware in the alarm centre
Part No.: Software status of the firmware in the alarm centre
Radio: Software status of the wireless communication
German: Software status of the OSD language
93