Installing And Training The Info Module - Abus Secvest 2WAY Installation Instructions Manual

3.4 Installing and training the info module

The example shows a house in four partitions. The status of each partition should be
displayed on each floor. Each partition can be activated or deactivated separately.
Therefore, an info module must be installed for each partition. Please note that the
info modules require a 12 V power supply.
1
2
3
4
Partition 1 (cellar)
Partition 2 (ground floor)
Partition 3 (garage)
Partition 4 (top floor)
Train the alarm centre to the info module.
In the installer menu:
Select the Info Module/Int Siren menu item.
Select the Teach Device
menu item.
Set the info module / internal siren to learning mode.
See the product instructions for more details.
After switching to learning mode, activate the transmission of wireless information
from the centre by pressing SEND. Ensure that each of the
info modules is assigned to the partition using the jumpers.
P1 = Partition 1
P2 = Partition 2
P3 = Partition 3
P4 = Partition 4
Info module
If the receiver beeps twice, the learn message was correctly received. End the
learning procedure by pressing Yes. Cancel the process by pressing No. The
learning procedure now starts again.
No further settings have to be made on the info module or internal siren. Even in the
event of power outage, the info module or internal siren retains the wireless
information of the alarm centre.
17
(cellar)
(ground floor)
(garage)
(top floor)