Editing The Arming Station - Abus Secvest 2WAY Installation Instructions Manual

Trigger the tamper contact on the arming station (see the station operating
instructions). When the arming station has been trained, the wireless alarm centre
beeps twice in acknowledgement. At the same time, the graphic display shows the
symbol next to the arming station number.

15.4.1 Editing the arming station

In the installer menu:
.
Select the arming station
Select the trained arming station 1.
Select the corresponding key.
Select the function from the table and allocate it to the arming station key. Confirm the
selection by pressing Select.
Function Meaning
Not Used This button has no function on the arming station.
Full Set After entering the user code and pressing this button, the
alarm centre is fully activated.
Part Set After entering the user code and pressing this button, a
partition of the alarm centre is activated internally.
Unset After entering the user code and pressing this button, the
alarm centre is fully deactivated.
Output On After entering the user code and pressing this button, an
output is activated.
Output Off After entering the user code and pressing this button, an
output is deactivated.
After assigning a function to the button, program all other buttons of the arming station
in the same way. For more details on the operation and installation of the arming
station, see the product instructions enclosed.
The entered user code defines which partition is activated or
deactivated. When the user code is authorised to activate partitions 1
and 3, then these are activated after the user code is entered and the
"Full Set" function key is pressed. This also applies to deactivation.
62