Primary Telecoms; Messages; Phone Book; Trigger - Abus Secvest 2WAY Installation Instructions Manual

20.28 Primary Telecoms

Select which primary transmission path should be used. This transmission path is used
as long as transmission is possible using it.

20.29 Messages

Select the corresponding function. For a list of functions and their attributes, see the
table below.
Function Meaning
Home Message Select this function and follow the instructions in the
(approx. 12 sec) display. This message is played back at every voice
message transmission. Record the data for the location
of the alarm centre here (name, address, city).
Trigger message 1-4 Recording of messages for different triggers. Four
(each approx. 8 sec) messages are available. For example, record "Fire
alarm", "Burglar alarm" etc.
At least one home message and one trigger message must be recorded. Do not
forget to save the message following recording.

20.30 Phone Book

Enter the phone numbers to be dialled. Phone numbers are assigned to messages
under the "Destinations" menu item. Press the star key to enter a dial pause. The dial
pause is displayed as a comma. Each dial pause interrupts the dial procedure for 3
seconds.
The wireless alarm centre can then be used to enter a name for this number. The
alarm centre shows these names in the phone book so that you can see which
destination was used for the message.
Please note that the last telephone number is designated as the Follow me number.
The wireless centre shows this number in the user menu. The user can enter a new
number in this field. This allows the user to forward all voice messages programmed
for this field.

20.31 Trigger

Up to five different triggers can be connected to each voice message using the
wireless alarm centre. A trigger is an option that can be selected from a list of alarm
types.
Select the Trigger menu point.
After Trigger has been confirmed with the Select button, the following graphic display
is shown: (Please note that the home message does not appear. This is always sent
by the alarm centre at the start of every transmission.)
Select a Message where a Trigger should be allocated.
At this point, you link a message with an event (trigger). Select the message to be
programmed. A list of five triggers is then shown on the display. Select a trigger. A list
of available alarm triggers is then shown. Select one of these for this trigger. After
selection of the alarm trigger, the list of triggers is shown again on the display. An
alarm trigger can be programmed for each of the five triggers in the list. When an
alarm is selected for each trigger, the alarm triggers are connected to the triggers and
one or more triggers are connected to a message.
Carry out this assignment for all four messages. After assigning a recorded voice
message to an event (trigger), assign it to one or more phone numbers to be dialled in
the event of an alarm trigger.

20.32 Destinations

Select a message where one or more phone numbers should be assigned.
86