Sia Report Mode; Sia Report Restorals - Abus Secvest 2WAY Installation Instructions Manual

20.10 SIA Report Mode

Select this, then select the Level of the transmission. The following table details which
events should be transmitted for the SIA 1 report.
Trigger Basic SIA
code
without
zone no. or
user
Medical control panel MA
Fire FA
Fire control panel FA
Fire control panel OK -
Fire OK -
Panic PA
Panic control panel PA
Panic control panel OK -
Panic OK -
Burglary BA
Burglary OK -
Cover tamper contact -
Cover tamper contact OK -
Tamper ext. siren -
Tamper ext. siren OK -
Tamper sensor TA
Tamper sensor OK -
Tamper system -
Tamper system OK -
Key box open -
Key box closed -
Technical alarm -
Technical alarm OK -
Power failure -
Power failure OK -
Reset -
Battery fault -
Battery fault OK -
Sum SIA Middle SIA Complete SIA
code without code with code with
zone no. or zone no. zone no.
user and user and user
MA MA MA
FA FA FA
FA FA FA
FR FR FR
FR FR FR
PA PA PA
PA PA PA
PR PR PR
PR PR PR
BA BA BA
- BR BR
TA TA TA
- TR TR
- TA TA
- TR TR
TA TA TA
- TR TR
TA TA TA
- TR TR
- BA BA
- BR BR
UA UA UA
UR UR UR
- - AT
- - AR
OR OR OR
- - YT
- - YR
Battery missing
Battery missing OK
ISDN/GSM fault
ISDN/GSM fault OK
PSTN fault
PSTN fault OK
Jamming
Supervision fault
Supervision fault OK
RF battery fault
Set
Internal active
Unset
Key switch set
Key switch unset
Download successful
Tamper user code
Omit zone
Man. trigger test report
Period. test report
Time / day changed
Prog. mode start
Prog. mode end
User code changed
User code deleted
Default password setting
loaded
End time limit
The following connection is recommended in Germany and Austria:
Under "Report Type", select SIA 1
Under SIA Report, select Basic
The codes are now transmitted according to the table without zone
numbers and users.
Under SIA Report, select Sum
The codes are now transmitted again according to the table without zone
numbers and users.
Under SIA Report, select Middle
The codes are now transmitted again according to the table with zone
numbers and users added.

20.11 SIA Report Restorals

Select whether the restoration of a function (closing of an alarm zone, error clearance)
should be transmitted to the command centre. If this function is disabled, only faults or
alarms are transmitted to the command centre but not the restoration (OK message) of
this function.
80
- - -
- - -
- - -
- - -
- - -
- - -
- - XQ
- - BZ
- - -
- - XT
- CL CL
- CL CL
- OP OP
CS CS CS
OS OS OS
- - RS
- JA JA
BB BB BB
RX RX RX
RP RP RP
- - -
- LB LB
- LS LS
- - -
- -
- - RH
EA EA EA
YM
YR
LT
LR
LT
LR
XQ
BZ
-
XT
CL
CL
OP
CS
OS
RS
JA
BB
RX
RP
JT
LB
LS
JV
JX
RH
EA