Installing a hot-swap power supply
This procedure applies only to server models that have hot-swap power supplies.
See "Installing a non-hot-swap power supply cage assembly" on page 153 for
information about the installation of a non-hot-swap power supply.
To install a hot-swap power supply, complete the following steps:
1. Remove the power supply filler.
2. Place the power supply into the bay guides.
3. Using the handle, push the power supply toward the front of the chassis until it
4. Connect one end of the power cord into the connector on the back of the power
5. Make sure that both the ac and dc power LEDs on the rear of the power supply
118
System x3400 Types 7973, 7974, 7975, and 7976: Problem Determination and Service Guide
Release latch
Power supply
locks into place.
supply and connect the other end of the power cord into a properly grounded
electrical outlet.
are lit, indicating that the power supply is operating correctly.
Power supply filler