Post-Upgrade Tasks; Installing Ia770 Patch (Or Rfu) Files, If Any - Avaya G700 Installation Manual

3. For other G700s in the stack, repeat the steps described previously to install firmware for
the stack processor, MGP, and media modules.
Installing G700 firmware in a remote, no stack configuration
If additional G700 media gateways are supported in the configuration, but they are not attached
as a stack, then you must configure each G700, with all of its devices, including the P330
processors. Additionally, you must check firmware and update the firmware as required.

Post-upgrade tasks

After the upgrade is complete, perform the following post-upgrade tasks:

Installing IA770 patch (or RFU) files, if any

Completing the upgrade process (S8300 is the primary controller)
Installing IA770 patch (or RFU) files, if any
Note:
The Avaya Installation Wizard cannot be used for this procedure.
Note:
If IA770 is being used, a post-upgrade update (patch) for IA770 may be required. See the IA770
documentation for procedures to install an update. The update file and documentation can be
found on the Avaya Support Web Site at http://support.avaya.com.
To obtain the post-upgrade update file and documentation
1. On the Avaya Support Web site, double click on Messaging in the list on the left.
2. Scroll down to the INTUITY links and double click on IA 770 INTUITY AUDIX Messaging
Application.
3. Double click on All Documents.
To download the IA770 patch software
1. Under Software Download, double click on IA 770 INTUITY AUDIX Embedded Messaging
Application Patches.
2. Double click on the update file name for this release.
For example, C6039rf+c.rpm.
on page 363
Post-upgrade tasks
on page 364
Issue 7 January 2005 363