Avaya G700 Installation Manual page 124

Installing a New G700 with an S8300
2. Type telnet 192.11.13.6 and press Enter.
The first RP screen should display.
NOTE: If you get the login prompt instead of the RP screen
If the telnet login prompt appears instead of the RP screen, the hard drive contains
a Communication Manager software release. In this case, if you have a USB
CD-ROM drive, connect the drive to a USB port on the S8300 and insert the unity
CD. Then log in to the telnet session (using the initial craft login) and use the
Shutdown Server feature on the Maintenance Web Interface to reboot the system.
After the reboot completes, telnet to 192.11.13.6 and the RP screen should now be
displayed.
If you do not have the USB CD-ROM, you cannot proceed with the upgrade
procedure described in this chapter. However, you can upgrade the Communication
Manger software using the procedure described in
Existing S8300B to R2.x
To upgrade using the procedure in
S8300B to R2.x
1. Complete the procedures starting at
files, if necessary
permanent
authentication files on your laptop and install them before doing the upgrade.
2. Return to this chapter and complete the procedures starting with
software version
3. Complete all the remaining procedures except installation of the license and
authentication files, which was done in step 1.
Alternatively, you can obtain a USB CD-ROM drive or an S8300B with only the RP
software and proceed from
software
124 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
and then return to this chapter.
on page 336 and ending with
on page 351. Note that you must have a copy of the license and
on page 275, using the initial craft login.
Remastering the hard drive and installing the upgrade
on page 269.
Chapter 6: Upgrading an
Chapter 6: Upgrading an Existing
Installing new license and authentication
Making the upgrade
Verifying