Renaming Old License And Authentication Files In S8300 Ftp Directory, If Necessary; Copying License And Authentication Files To The S8300 Hard Drive (From Your Laptop) - Avaya G700 Installation Manual

Note:
If the S8300 is already set up for remote access, Avaya services personnel can
Note:
copy new license and authentication files directly into the FTP directory on the
server. Avaya personnel will notify you when the new files are in place as agreed
(for example, by telephone or E-mail). After they are loaded into the FTP
directory, install them using the License File and Authentication File screens
from the S8300 main menu web-page.
Note:
Before an upload or download, be sure the S8300 FTP directory (/var/home/ftp/
Note:
pub) contains no files with a .pwd or .lic extension. Only one of these files can
exist in this directory. If one exists, move, rename, or delete it.
Renaming old license and authentication files
in S8300 FTP directory, if necessary
Before an upload or download, be sure the S8300 FTP directory (/var/home/ftp/pub) contains
no files with a .pwd or .lic extension. Only one of these files can exist in this directory. If one
exists, move, rename, or delete it.
To rename old license and authentication files in S8300 FTP directory
1. Open a telnet session on the S8300.
2. At the command prompt, type cd /var/home/ftp/pub and press Enter.
3. Type ls -l and press Enter.
The system displays a list of files.
4. Check the list of files to see if any files with .lic or .pwd suffixes are in the directory.
5. If any .lic or .pwd files exist, rename them.
For example, type mv <filename>.lic
mv <filename>.pwd
6. Leave the telnet session open for a later task.
Copying license and authentication files to the
S8300 hard drive (from your laptop)
Use the following procedure to transfer the license and password files from the CD or hard drive
on your laptop to the S8300 hard drive.
To copy license and authentication files to the
S8300 hard drive from your laptop
1. Log on to the S8300 Web Interface
<filename> .lic.old, or
<filename> .pwd.old and press Enter.
On-site Preparation for the Upgrade
Issue 7 January 2005 337