Avaya G700 Installation Manual page 203

4. At the P330-1(configure)# prompt, type
set interface inband < vlan> <ip_address> <netmask> to assign an IP
address to the P330 stack processor.
<vlan> is the vlan number, usually 1, to be established on the S8300 for the G700 Media
Gateways. The <ip_address> <netmask> is the assigned address and subnet for the
P330 stack processor.
5. Type reset and press Enter to reset the stack.
Select Yes at the dialog box that asks if you want to continue.
All LEDs flash. As the unit powers up, self-tests are run. When the G700 MPG or P330
stack processor has reset, login again to continue.
6. Login at the Welcome to P330 menu.
The prompt P330-1(super)# appears.
7. Type configure to obtain the P330-1(configure)# prompt.
To establish IP routing for the stack
1. Type show interface inband to verify that the Avaya P330 stack server (Layer 2
Switching Processor) has the correct address.
2. Type set ip route 0.0.0.0 <default-gateway> to specify the gateway to handle
addresses outside of the local subnet.
<default-gateway> is the IP address of the customer's default network gateway. This
address should be available in the planning documentation.
3. Press Enter to save the destination and gateway IP addresses.
4. Type show ip route .
The route net and route host tables appear. Verify that the information is correct.
After you have configured the P330 stack processor, you assign an IP address to the G700
Media Gateway Processor (MGP). Your first task is to check the serial number of the MGP.
To check the serial number of the G700 media gateway processor
1. At the P330-1(configure)# prompt, type session mgp.
2. At the MG-???-1(super)# prompt, type show system to list various attributes of the G700.
The system displays a list of attributes, as shown in the following example:
Configure the G700
Issue 7 January 2005 203