Paging And Announcement Equipment - Avaya G700 Installation Manual

Paging and announcement equipment

This section provides information on loudspeaker paging
On a G700 or G350 Media Gateway, the loudspeaker paging feature is connected through a
port on an MM711 Analog Media Module.
The G700 or G350 Media Gateway does not support an auxiliary trunk circuit pack. Therefore,
the loudspeaker feature through an auxiliary trunk is not supported on a G700 or G350 Media
Gateway.
Note:
Users on a G700 or G350 Media Gateway controlled by an S8700/S8710 or
Note:
S8500 can also access the loudspeaker paging feature if equipment is physically
connected to a TN763 auxiliary trunk circuit pack in an PN carrier of an the
S8700/S8710 or S8500 system.
Figure 38 shows the connections for loudspeaker paging, dial dictation, or recorded
announcement features on a G700 or G350 Media Gateway.
Figure 38: Typical loudspeaker equipment connections for a G700 or G350 Media Gateway
1
cydfspkKLC 091802
Figure notes:
1. G700 or G350 Media Gateway
2. MM711 Analog Media Module
3. RJ-45 connection
To hook up loudspeaker paging from a G700 or G350 Media Gateway
1. Connect one end of an RJ-45 cable to a port in the MM711 Analog Media Module.
2. Connect the other end of the RJ-45 cable to a customer-supplied telephone hybrid device.
3. Follow the manufacturer's instructions to properly connect the telephone hybrid device to
your loudspeaker paging system.
4. Administer the switch for the new equipment.
ALM SO EI SM EM SI EO
TST
ACT
SIG
E1/T1
ALM ALM
TST TST
ACT ACT
SHUT DOWN
OK TO
REMOVE
SERVICES USB 1 USB 2 1 2 3 4
ALM
TST
ACT
1 2 3 4
3
EIA 530A DCE
2
5 6 7 8
5 6 7 8
4
4. Telephone hybrid (third party)
device
5. Loudspeaker paging system
Paging and announcement equipment
5
Issue 7 January 2005 459