Administering The Lsp Form - Avaya G700 Installation Manual

Table 9: IP interfaces field descriptions (continued)
Field
VLAN
Number of CLAN
Sockets Before
Warning
3. Close the screen.

Administering the LSP Form

If the primary server has LSPs, you must enter the LSP node names on the LSP form to enable
the LSPs to get translations updates from the primary controller. Once the LSPs are
successfully entered on the LSP form, their status can be viewed with the display lsp
command.
Note:
The LSP node names must be administered on the node-names-ip form before
Note:
they can be entered on the LSP form.
To add LSP names to the LSP screen
1. At the SAT prompt, type change lsp to open the LSP screen.
LSP Screen
change lsp
Number NAME
1 node-10-LSP_
2 ____________
3 ____________
4 ____________
5 ____________
6 ____________
7 ____________
8 ____________
9 ____________
10 ____________
11 ____________
12 ____________
13 ____________
14 ____________
15 ____________
16 ____________
Conditions/Comments
The VLAN number assigned to the C-LAN, if any.
The threshold for the number of sockets used by this
C-LAN that triggers a warning message to be sent to the
error log.
LOCAL SURVIVABLE PROCESSOR
IP Address
192.168.1.50
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
out-of-service
Administer Communication Manager
Page 1 of
Service Translations
State? Updated
in-service 14:21 5/4/2003
Issue 7 January 2005
2 of 2
16
181