Installing New Firmware On The Media Modules - Avaya G700 Installation Manual

Example: Show mg list_config
SLOT TYPE
---- ------ -----
V0 G700
V1 ICC
V2 DCP
V3 ANA
V4 DS1

Installing new firmware on the media modules

For upgrades of active media modules, you need to take the media modules out of service
before initiating the upgrade process. To do this, go to a SAT session on the primary controller
and issue a busyout command.
Note:
Skip this busyout procedure if the media modules are not in service; for example
Note:
during an initial installation.
To busyout board (for active media modules)
1. Go to a SAT session on the primary controller and enter the command,
busyout board vx
where x is the slot number of the media module to be upgraded.
2. Verify the response,
Command Successfully Completed
3. Repeat for each media module to be upgraded.
To install media module firmware
1. Be sure that you have checked for the current vintage of the VoIP Module for the v0 slot (on
the G700 motherboard).
This VoIP module does not occupy a physical position like other media modules.
2. At the P330-1(configure)# prompt, type session mgp.
3. At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
4. Type copy tftp mm-image v<slot #> <filename mm>
<tftp_server_ip_address>
where
<slot #> is the slot of the specific media module,
<filename mm> the full-path name of the media module firmware file in a format such as
CODE SUFFIX HW VINTAGE
------ ----------
DAF1 A 00
S8300 A 72
MM712 A 2
MM711 A 2
MM710 A 1
Install New Firmware on the G700 Media Gateway
FW VINTAGE VOIP FW
---------- -------
230(A) 67
00 N/A
58 N/A
57 N/A
58 N/A
Issue 7 January 2005 217