Getting Ia770 Data And Stopping Ia770; (If Ia770 Is Being Used) - Avaya G700 Installation Manual

!
CAUTION:
The LSP's Communication Manager must remain shut down while you upgrade
CAUTION:
the primary controller. When you complete the primary controller upgrade, run
save translation on the primary controller before restarting Communication
Manager on the LSP. The save translations process will automatically cause the
G700's endpoints to reregister with the primary controller.
After the primary controller has been upgraded, you need to restart the LSPs.
To disable alarm origination
If alarm origination is enabled during the upgrade, unnecessary alarms will be sent to the
Operations Support System (OSS) destination number(s). Even if you selected Suppress
Alarm Origination when you logged in, alarm origination will be automatically re-enabled when
the system reboots after the software upgrade. Use this procedure to prevent alarm origination
from being re-enabled after reboot.
!
CAUTION:
If you do not disable alarm origination, the system can generate alarms during
CAUTION:
the upgrade, resulting in unnecessary trouble tickets.
1. Logoff the SAT session.
2. At the command prompt, type almenable -d n -s n, where
-d n sets the dialout option to neither (number)
-s n disables SNMP alarm origination
Note:
Be sure to reset alarm origination after the upgrade.
Note:
3. Type almenable (without any options) to verify the alarm origination status.
You should see:
incoming: enable
Dial Out Alarm Origination: neither
SNMP Alarm Origination: n

Getting IA770 data and stopping IA770

(if IA770 is being used)

Skip to Backing up system files
If IA770 is being used, you need to collect data, leave a test message, and shut down IA770
before backing up the files.
About the major tasks to upgrade the S8300A to release 2.1
on page 259 if IA770 is not being used.
Issue 7 January 2005 255