Post-Upgrade Tasks - Avaya G700 Installation Manual

Upgrading an Existing S8300A to R2.2
3. For other G700s in the stack, repeat the steps described previously to install firmware for
the stack processor, MGP, and media modules.
Installing G700 firmware in a remote, no stack configuration
If additional G700 media gateways are supported in the configuration, but they are not attached
as a stack, then you must configure each G700, with all of its devices, including the P330
processors. Additionally, you must check firmware and update the firmware as required.

Post-upgrade tasks

Complete the following tasks after you have finished the upgrade:
If using IA770:
1. Install and restart IA770
2. Saving translations
3. Installing IA770 patch (or RFU) files and optional language files, if any
Complete the upgrade process (S8300 is the primary controller):
4. To check media modules
5. To enable scheduled maintenance
6. To busy out trunks
7. To check for translation corruption
8. To resolve alarms
9. To re-enable alarm origination
10. To back up the system
11. To restart LSPs (if any)
306 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
on page 307
on page 313
on page 314
on page 314
on page 315
on page 315
on page 315
on page 315
on page 315
on page 315
on page 313