Avaya G700 Installation Manual page 157

!
CAUTION:
If you need to change the mgc list, you must run clear mgc list before
CAUTION:
running set mgc list again.
Table 8 describes the possible optional controllers for an S8300 and S8700/S8710 primary
controller:
Table 8: Possible optional controllers for various primary controllers
If primary
controller is
S8300
S8500 or
S8700 or
S8710
Note:
For an S8500 or S8700/S8710 primary controller, the last three IP addresses in
Note:
the list can be either the addresses of C-LANS (which are connected to the same
S8500 or pair of S8700/S8710s that act as primary controllers) or addresses of
LSPs. If you enter a combination of both, you must list C-LANs first and the LSPs
last, after the C-LANs.
2. Type reset mgp at the MG-???-n(configure)# prompt to reset the G700 media gateway
processor.
A system prompt asks you to confirm the reset.
3. Select Yes at the dialog box that asks if you want to continue.
The G700 media gateway processor resets. The LEDs on the G700 media gateway and the
media modules flash. These elements each conduct a series of self-tests. When the LEDs
on the media modules are extinguished and the active status LEDs on the G700 media
gateway are on, the reset is complete.
The system ultimately returns you to the P330-1 (configure) prompt.
At the P330-1(configure)# prompt, type session mgp.
At the MG-001-1(super)# prompt, type configure to change to the configuration mode.
Then, controller IP addresses can be
First: IP address of the S8300 primary controller.
Next three: one, two, or three IP addresses of S8300s
configured as LSPs.
First: IP address of the C-LAN for the S8500 or S8700/
S8710 primary controller.
Next three: one, two, or three IP addresses of alternate
C-LANs and/or LSPs.
Configure the G700 Media Gateway
Issue 7 January 2005 157