Avaya G700 Installation Manual page 155

To run the ping command
1. At the MG-???-n(config)# prompt, type ping mgp <IP_address>
where <IP_address> is the address of an S8300, S8500, or S8700 Media Server, the VoIP
engine, or any other functioning endpoint accessible on the customer's LAN. It is
recommended to ping endpoints on both the same subnet and a different subnet.
Ping results appear on the screen, similar to the following example.
Ping MGP results
MG-???-1(configure)# ping mgp 135.122.49.55
PING 135.122.49.55: 56 data bytes
64 bytes from 135.122.49.55: icmp_seq=0. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=1. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=2. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=3. time=0. ms
64 bytes from 135.122.49.55: icmp_seq=4. time=0. ms
----135.122.49.55 PING Statistics----
5 packets transmitted, 5 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
2. Check that the same number of packets transmitted were also received.
3. Type ping voip v0 <IP_address>
<IP_address> is the address of the G700, or any other functioning endpoint on the
customer's LAN.
Ping results appear on the screen, similar to the following example.
Ping VoIP results
MG-???-1(configure)# ping voip v0 135.122.49.55
----135.122.49.55 PING Statistics----
5 packets transmitted, 5 packets received, 0 packet loss
round-trip(ms) min/avg/max = 0/1/0
Configure the G700 Media Gateway
Issue 7 January 2005 155