Verifying Software Version; Copying Files To The S8300 Hard Drive - Avaya G700 Installation Manual

Installing a New G700 with an S8300
Arrange access to another hard drive (comcode 700307028) should it be necessary to
perform the TFTP remaster procedure on it.
Tip:
You can use the Avaya Installation Wizard to perform all of the following
Tip:
procedures up to

Verifying Software Version

Note:
Since the system is now running a new software release, you must login with the
Note:
initial craft ID and password. (You cannot use dadmin at this point.)
To verify the software version:
1. Log on to Integrated Management and launch the Maintenance Web Interface.
2. Under Server, click Software Version.
3. Verify that the media server is running Release 2.2software.
The Report as: string should show R012x.01 at the beginning of the string. For example,
R012x.01.0.411.1.
Tip:
Normally, you would need to use the Make Upgrade Permanent function on the
Tip:
Web Interface at this point. However, this is not necessary for this upgrade
because there is no previous software version in the alternate partition.

Copying Files to the S8300 hard drive

During reformatting of the hard drive, a new directory, /var/home/ftp/pub, was created. For
release 2.0 and later, this pub directory will be used in place of the /var/home/ftp directory that
was used in previous releases.
You must copy the remaining required files to the pub directory on the S8300 hard drive. This
includes, but is not limited to:
Post-upgrade software update (patch)
License file
Avaya authentication file
New firmware files
128 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Configure the G700 Media Gateway on page 150.