On-Site Preparation For The Upgrade; Accessing The P330 Stack Processor - Avaya G700 Installation Manual

6. Click on Save this file to disk.
7. Save the file to the C:\tftp directory (or your alternate tftp location).
8. Use WinZip or another zip file tool to unzip the file, if necessary.

On-site preparation for the upgrade

Before installing new firmware on the G700 processors and medial modules you need to
prepare on-site by:

Accessing the P330 stack processor

Verifying the contents of the tftpboot directory
as described in this section.
Accessing the P330 stack processor
See About Connection and Login Methods
and login.
Log on to the P330 stack processor using one of the following methods:
Using a LAN connection, telnet to the IP address of the P330 stack processor and log in.
If you are not using your laptop as the TFTP server, you can connect your Laptop directly
to the G700 Console (Serial) Port. Then use HyperTerm or a similar terminal emulation
application to log in to the P330 stack processor Command Line Interface (CLI).
You are now logged-in at the Supervisor level with prompt P330-1(super)#.
On-site preparation for the upgrade
on page 373
on page 374
on page 45 for details on how to set up a connection
Issue 7 January 2005 373