Install New Firmware On The G700 Media Gateway; Installing New Firmware On The P330 Stack Processor; Setting Rapid Spanning Tree On The Network - Avaya G700 Installation Manual

Installing a New G700 without an S8300

Install New Firmware on the G700 Media Gateway

Follow the procedures in this section to install firmware on the G700 processors and media
modules.
This section covers:

Installing New Firmware on the P330 Stack Processor

Installing new firmware on the G700 Media Gateway Processor
Installing new firmware on the media modules
Installing New Firmware on the P330 Stack Processor
To install P330 stack processor firmware
1. Accessing the P330 Stack
2. At the P330-1(configure)# prompt, type
copy tftp SW_image <file> EW_archive <ew_file>
<tftp_server_address> <Module#>
where <file> is the full-path name for the image file with format and vintage number
similar to viisa3_8_2.exe,
<ew_file> is the full-path name for the embedded web application file with format similar
to p330Tweb.3.8.6.exe,
<tftp_server_ip_address> is the IP address of the TFTP server, and
<Module#> is the number, 1 through 10, of the media gateway in the stack. If there is only
one G700 media gateway, the number is 1.
3. Verify that the download was successful when the prompt returns:
a. type show image version <module #> and check the version number in the
Version column for Bank B.
b. type dir <module #> and check the version number in the ver num column for the
EW_Archive file.
4. Type reset <module #>.

Setting rapid spanning tree on the network

Spanning Tree (STP) is a loop avoidance protocol. If you don't have loops in your network, you
don't need STP. The "safe" option is always to leave STP enabled. Failure to do so on a network
214 Installation and Upgrades for Avaya G700 Media Gateway and Avaya S8300 Media Server
Processor.