Prepare To Install Firmware On The G700; Accessing The P330 Stack Processor; Verifying The Contents Of The Tftpboot Directory - Avaya G700 Installation Manual

Prepare to install firmware on the G700

Before installing new firmware on the G700 processors and media modules, you need to:

Accessing the P330 Stack Processor

Verifying the contents of the tftpboot directory

Accessing the P330 Stack Processor
See About Connection and Login Methods
and login.
Log on to the P330 stack processor using one of the following methods:
Using a LAN connection, telnet to the IP address of the P330 stack processor and log in.
If you are not using your laptop as the TFTP server, you can connect your Laptop directly
to the G700 Console (Serial) Port.
Then, use HyperTerm or a similar terminal emulation application to log in to the P330 stack
processor Command Line Interface.
You are now logged-in at the Supervisor level with prompt P330-1(super)#.
Verifying the contents of the tftpboot directory
Before proceeding with the G700 firmware installation, you should check the /tftpboot directory
on the TFTP server to make sure the firmware versions match those listed in the planning
documentation. If they do not, you must copy the correct firmware versions into the /tftpboot
directory using the following procedure:
1. Download the firmware files from the support Website to your laptop.
2. Using the Web Interface on the S8300 Media Server, copy the firmware files from your
laptop to the /var/home/ftp/pub directory on the S8300, or
Alternatively, you can "ftp" the files from your laptop to the pub directory.
3. Copy the firmware files from the pub directory to the /tftpboot directory, using the S8300
Media Server command line interface.
Note:
For detailed information on this procedure, see "Appendix 2" in Job Aid:
Note:
Replacing the G700 Media Gateway, 555-245-752, Issue 4, January, 2005.
Prepare to install firmware on the G700
on page 45 for details on how to set up a connection
Issue 7 January 2005 211